Concrete slab & basement mitigation

Sub-Slab Depressurization in Lehi, UT

Connect with an independent local mitigation specialist to plan suction points, routing, and fan sizing for your basement slab.

Why is sub-slab depressurization the standard fix for Lehi basements?

Active sub-slab depressurization (SSD)—also called active sub-slab suction—is the workhorse mitigation technique across Lehi and Northern Utah County. Most homes from Traverse Mountain and Thanksgiving Point down through American Fork, Highland, and Saratoga Springs sit on poured concrete basement slabs or walkout foundations. Because indoor air pressure is typically slightly lower than soil gas pressure—especially when Utah furnaces run in winter—radon naturally moves upward through hairline slab cracks, perimeter cove joints, control cuts, and plumbing box-outs.

An active SSD system reverses that pressure gradient. By creating a stronger vacuum beneath the concrete than the house itself exerts, the system captures radon in the gravel or soil layer below your floor and vents it safely outside above the roof.

How does soil beneath Northern Utah County slabs affect SSD design?

Soil permeability directly controls how easily vacuum spreads under your concrete floor:

  • Coarse Lake Bonneville bench gravels (Highland, Alpine, Cedar Hills, East Lehi): Loose sand and gravel layers transmit radon readily into unmitigated homes, yet those same porous sub-slab soils often allow a single well-placed suction point to depressurize an entire basement footprint effectively.
  • Tighter clay and silt valley soils (West Lehi, Saratoga Springs lake flats, Vineyard): Fine-grained sediments resist airflow, so an independent contractor may perform a pressure-field extension test before deciding on fan curve strength, pit excavation volume, or a second suction point.
  • Stepped walkout and multi-level slabs (Traverse Mountain, SunCrest, Eagle Mountain): Split-elevation footings and interior load-bearing stem walls can block sub-slab airflow between upper and lower bays, requiring careful diagnostic testing so both slab zones achieve negative pressure.

Core engineering details to ask your contractor about

  • Fan location: EPA guidelines state the radon fan must NEVER be installed inside or beneath conditioned living space—it belongs in an unconditioned attic, attached garage attic, or exterior wall enclosure so any pipe leak inside the house stays under negative pressure.
  • Discharge point: Exhaust piping must terminate above the roofline and away from operable windows, soffit vents, and decks so discharged gas disperses safely outdoors.
  • Manometer warning device: Every active system requires a visual or audible pressure indicator (typically a liquid U-tube manometer) mounted where you can check it regularly.
  • Freeze protection: Northern Utah County winters bring sub-freezing nights; proper pipe slope allows condensation inside the vent stack to drain back beneath the slab rather than freezing inside the fan housing.

Get a Free Estimate

Areas We Cover in Northern Utah County

Sub-slab depressurization system components

Each component works together to maintain continuous negative pressure beneath the foundation slab.

Cored suction pit and aggregate pocket

A hole cored through the concrete slab with soil excavated beneath to create an open vacuum pocket that pulls gas across the sub-slab footprint.

Sealed 3-inch or 4-inch PVC vent stack

Rigid schedule-40 PVC piping routed through a mechanical room, garage, or exterior chase, sloped to drain moisture and labeled as a radon vent.

Continuously rated inline radon fan

Sized to match your home's sub-slab soil resistance—high-suction fans for dense clay soils or high-flow fans for coarse gravel benches.

U-tube manometer and slab crack sealing

Polyurethane sealant closes major floor cracks and sump lids while a mounted liquid gauge shows live vacuum pressure in inches of water column.

Published EPA performance & Utah SSD cost benchmarks

MetricPublished figurePublic source
Active sub-slab suction reduction50% to 99% (up to 99%)U.S. EPA Consumer's Guide
Passive sub-slab suction reduction (no fan)30% to 70%U.S. EPA Consumer's Guide
Active SSD system in an existing Utah home$1,200 to $1,700Utah Geological Survey
Typical residential active systemAround $1,500 to $2,000Utah DEQ guidance

Multi-point suction layouts, finished basement soffit routing, and heavy clay sub-soils can push quotes above basic single-point ranges.

Why Use a Referral for Sub-Slab Depressurization?

Matched to local soil conditions

Independent Northern Utah County contractors regularly work on both porous Wasatch bench gravels and tighter Utah Lake basin clays.

Clean routing for finished basements

Discuss mechanical-room closets, garage chases, or color-matched exterior runs directly with the contractor during your walkthrough.

Pressure-tested performance focus

Ask your contractor about pressure-field extension checks and written post-mitigation target levels in your contract.

Zero fee to request an estimate

Use our online form to share your Lehi or Northern Utah County slab layout and receive a free direct quote.

Contact Us Today for a Free Estimate

Have a basement slab or walkout foundation in Lehi or Northern Utah County? Submit your home details for a free sub-slab mitigation quote.

Get a Free Estimate

Free — no obligations

Steps in a sub-slab depressurization install

1. Foundation walkthrough & suction check

The independent contractor inspects floor layouts, utility rooms, sump pits, and potential vent paths to the attic or exterior.

2. Slab coring & pit excavation

A clean suction hole is cored into the concrete and sub-slab aggregate or soil is cleared to form an effective air collection chamber.

3. Pipe routing, sealing & fan wiring

Sealed PVC risers connect to an exterior or attic radon fan wired to code, with major slab joints and sump lids sealed airtight.

4. Manometer labeling & post-install retest

The contractor mounts and marks the U-tube manometer, and you verify the drop with a follow-up radon test 24 hours to 30 days later.

Radon Mitigation Services Available in Lehi, UT

Get a Free Estimate